Setting Out A Roof For Slating

This is also the lathing gauge for that course.

Setting out a roof for slating.

Measure between the top of the top batten and the top of. The gutter will be formed in cast aluminium. The width of the first course slates was 12 a very heavy thick slate to cut. Alternatively the fascia board can be raised slightly in order to raise the bottom of the starter course.

The first thing to do is work out the slate exposure as you would for normal slating the length of the slate minus the headlap divided by 2 the exposure. For example a 20 inch slate with a 3 inches headlap would have an 8 5 inches exposure 20 inches 3 inches 2 81 2 inches. Then determine the position of the highest batten at the top typically the top of the uppermost row of slates tiles. Work towards both verges with the remaining under eaves slates.

Locate the centre point of the eaves and centre the first under eaves slate. Traditionally this has been done by nailing a cant or shim strip made from wood under the bottom edge of the starter course usually the same wood that is used to create the roof deck see photos below. The building will have an exposed timber eaves. Generally speaking 20degrees is the lowest advisable pitch for a slate roof depending on the size of the slates and how much that the roof is exposed to moderate weather conditions.

First courses of slating on the main roof note the undereaves slates fitted upside down to form a drip with the first course slates. You should have all of these tools plus a nail belt chalk line utility knife and a collection of ladders. Lay the first full slate over the top of this under eaves slate and cut the slates on both verges to the same width. Cut the second under eaves course from the same slate as the first course.

Installation when laying out a roof in preparation for slating it chalk lines across the entire roof area marking the top edge of every row of slate.