So if you re dealing with four inch tiles your batten board would start three inches off the floor.
Setting large wall tiles.
Don t start it at the floor.
So if the tiles are 10 inches high the line should be 10 25 inches off the floor.
Instead bring it up to about 3 4 of the height of your tiles.
Mark a horizontal line along the bottom of the wall coming up from the floor by the height of your tile plus one quarter inch.
Set the tiles evenly about a horizontal feature window basin etc.
Try to achieve a full tile height above the side of a bath worktop.
With traditional tile that is less than 15 x 15 there can be up to a 1 4 variance in the substrate over a 10 span.
For tile with at least one edge greater than 15 the american national standards institutes ansi recommends a maximum variance of 1 8 over a 10 span and 1 16 over a 24 span.
To avoid this cancel and sign in to.
Keep the tiles in a.
So that equal width tiles are on both sides.
If playback doesn t begin shortly try restarting your device.